Cable Tie Mounting Bases from JET PRESS

Cable ties are tried and trusted method of quickly securing cables. Our cable tie mounting bases further extend the useful of cable ties by easily allowing the ties to be fixed to panels or other sheet materials.

Available in metal or plastic, designs are offered that fit on the edge of panels or inserted into panel holes or securely screwed in place or stuck on surfaces by self-adhesive bases.

Metal Edge-Fitting Cable Tie Mounting Bases

These metal edge-fitting mounting bases clip onto the edge of panels and give an anchor point for cable ties.

The clip is pushed or tapped onto the panel edge and the barbs of the fastener hold it securely in place. The raised slot on the surface of the clip can accommodate standard or a releasable cable ties of up to 5  [....]

More details

Metal Edge-Fitting Universal Mounting Bases

These Universal Edge-Fitting Cable Tie Mounting Bases have a multi-purpose base to fit onto a panel edge, and can be installed by hand or softly with a hammer.

Suitable for cable ties, studs or plastic clips for holes 6.5-6.7mm and instant application is achieved with the barb design.

Material - Carbon Steel

More details

Push-In Cable Tie Mounting Bases

Plastic Push-In Mounting Bases are intended for use in pre-drilled holes and provide a fixing for Cable Ties up to 8mm wide. Once inserted into the hole, the mounting base is locked into place and the cable tie can be passed through the slot.

This plastic cable tie mounting base is used widely for a variety of wiring r  [....]

More details

Screw Fix Cable Tie Mounting Bases

Screw Fixing Cable Tie Mounting Bases hold cables and harnesses clear of the panel surface. The Eyelet type can be used with cable ties up to 5mm wide, and the Cradle type is suitable for ties up to 9mm wide.

These are typically used for any application where the routing cable and wire bundles are needed on surfaces th  [....]

More details

Self-Adhesive Cable Tie Mounting Bases

Self-Adhesive Bases accommodate Cable Ties of up to 5mm wide, and will bond securely and permanently to most surfaces. For additional strength, a number of these cable tie bases come with a centre hole to facilitate fixing with a wood screw or self-tapping screw.

C = Maximum Cable Tie width.

Typical applicatio  [....]

More details

Edge-Fitting Cable Tie Mounting Bases

These Edge-Fitting Cable Tie Mounting Bases accommodate Cable Ties of up to 4.8mm wide, and the two entry points allow the Cable Tie to be mounted along the panel or at 90° to the panel edge.

C = Maximum Cable Tie width.
P = Panel thickness.

Typical applications include domestic applicances, electrical equi  [....]

More details