These Installation Tools are used in conjunction with our range of standard panel mounting clips.

10mm Drill Bit with Shoulder

This 10mm Drill Bit is for drilling through the panel and creating a pilot hole for INT049.

Use in conjunction with the installation of male self-tapping clips within our standard and low profile ranges.

More details

10mm Panel Drill Bit Forstner Type

This Forstner Type 10mm Panel Drill Bit is used for drilling blind holes into the back of panels, use in conjunction with the standard and low profile ranges.

Use drill gauge INT038 as shown in associated products.

More details

Step Drill Bit Tungsten Tip

This 16.8mm diameter Tungsten Tipped Drill Bit is used for drilling out a 10mm hole in the frame and is used in conjunction with the Self-Tapping Panel Mount Socket - FMS009.

See associated products below for compatible clips and installation tools.

More details

Step Drill Bit Carbide Tip

This 16.8mm diameter Carbide Tipped Drill Bit is used for drilling holes in fibreglass, carbon fibre and kevlar laminates, use in conjunction with the Self-Tapping Panel Mount Socket - FMS009.

See associated products below for compatible clips and installation tools.


More details

Tap Tool

This Tap Tool is for tapping a thread to fit our Self-Tapping Panel Mount Socket - FMS009 into fibreglass, aluminium or similar material. Either drill a hole with INT044 or drill out a 10mm hole with INT049 then tap with this tool.

See associated products below for compatible clips and installation tools.

More details

Installation Tool for Panel Mount Socket

This Installation Tool is for use with our Self-Tapping Panel Mount Socket - FMS009 with battery drill on correct torque setting.

See associated products below for compatible clips.

More details

Installation Tool for Self-Tapping Clips

This Installation Tool is used to install the self-tapping male clips shown below with the battery drill on correct torque setting.

Self-tapping male clips - FMS005, FMS007, FMS013, FMS014, FMS015 - see associated products below.

More details

Drill Gauge for Drill Bit

This Drill Gauge is for use with INT034 Drill Bit. It is designed for depth control when blind drilling, use in conjunction with standard and low profile male clips.

Machined aluminium housing, anodised red for durability.

More details

Profile Centre Point Stainless Steel Tip

This Profile Centre Point with stainless steel tip aligns blind holes in the panel to ensure correct clip alignment of the panel and frame.

Fits a 10mm blind hole in the panel when drilled with INT034 or into FMS008, FMS009, FMS010, FMS012 - see associated products below.

This Profile Centre Point has a stainle  [....]

More details

Adjustable Drill Guide Installation Jig

This Adjustable Drill Guide is designed for use with FMS012 - see associated products below.

More details

Panel Removal Tool

This Panel Removal Tool is used for removing upholstered panels only.

Not for use on painted panels.

Material - Stainless Steel.

More details

Glass Suction Panel Removal Tool

This Glass Suction cup is used for the removal and handling of painted and pre-finished panels. To ensure the controlled removal of panels, two glass suckers are required.

This Glass Suction cup has a load capacity of 40kg.

More details

Installation Tool Kit

This Installation Tool Kit contains the following 6 tools:- INT033, INT034, INT035 INT037, INT047, INT049

More details

Service Maintenance Kit

This Service Kit is for on-board and on-site maintenance of the standard profile range.

More details