The Accuride locking handle kit is used for rugged drawer applications that require a locking system for front and rear mounted units.
- Suitable for drawers up to 1.5m wide
- Centrally located push-button lock mechanism
- Corrosion resistant
- Lightweight and easy to install
- Can be used alone or with Accuride slides of a 17.5mm thickness and above
Handle kit: (SBA043)
- 1 x handle and lock-in mechanism (item A & B)
- 1 x push-button
- 2 x bar support blocks (item C)
- 2 x lock blocks (item D)
- 2 x pins
500mm locking bars - applications up to 1122mm wide: (SBA044)
- 2 x stainless steel bars - 10mm diameter
750mm locking bars - applications up to 1622mm wide: (SBA045)
- 2 x stainless steel bars - 10mm diameter
Lock-out conversion kit: (SBA046)
- 2 x push-buttons
- 2 x lock blocks
- 1 x guide bracket
Notes:
- Customer cuts bar to correct length and drills hole for pin (pins supplied)
- The lock-out cannot be used on over-extension (100%+) slides
- Customer to supply 10mm rod, threaded to M10 for a min. of 25mm at each end to connect push-buttons for lock-out conversion kit
Materials - Mild Steel, Stainless Steel
Finish - Zinc Plate & Black Passivate
