Palnut Regular Lock Nuts - DIN7967 from JET PRESS
Palnut Regular Lock Nuts secure bolts in applications where vibration or dynamic load might cause them to become loose.
These Palnut Regular Lock Nuts are a cost effective solution. They are inexpensive and do not require a torque wrench to install them, so installation is quick and easy. The installer turns the Lock Nut to finger tight then uses a spanner to tighten them a further third to half a turn. Once properly tightened, the hex face becomes slightly concave. This means they can be checked with a simple visual inspection which is less expensive than other Lock Nut systems.

Under M5 they can be used alone, for M6 and above they must be used in conjunction with a regular full nut.

Manufactured to DIN7967 standards

• Resists loosening caused by vibration or dynamic load
• Improves structural integrity and performance
• Ease of assembly
• Low cost

Typical applications:
Construction Equipment, Pipework, Agricultural Equipment, Manufacturing Equipment.

Material - Austempered Carbon Steel

For samples, prices or further information please click the enquiry button or ring +44 1623 551 800.

You can contact us about this product directly on the form below. Please send us the details of any question, or help that we can provide you.

Please add 6 and 1 and type the answer here:

Drawings and images are for reference only and should not be used for product specification. For new applications we recommend that you carry out assembly tests using samples supplied by us.

DescriptionPart NrThreadWH

All dimensions are mm unless specified.

Other Products in Lock Nuts & Lock Washers